The beauty of window tint installation is that you can opt to go for a DIY installation or you can seek the assistance of a professional.

Whether you plan to buy UV window film around Oviedo, FL, or if you’re interested in frosted film in Oviedo, FL, the details in this article are crucial. If you choose to seek the assistance of a well-trained technician, best of luck! If you opt to do it yourself, here are some things that you should consider.

Pre-cut Window Films

Cutting the window tint by yourself is risky as you may cut it incorrectly and it would only result in a waste of money. Installing a pre-cut window film is average. Of course, if you are on a budget, your worry about the tint cost near Oviedo, FL, you would want to cut the window film by yourself – that’s not entirely bad.

However, it is fortunate that you can actually avail of pre-cut tint in Oviedo, FL, and simply stick it on your vehicle – it’s a whole lot easier.

The Basics

But going back to cutting window films, you should always remember to leave a few inches of space because you will be tucking the excess film through your window. Normally, for those who are used to doing DIY window tinting, they would normally use a card to tuck the excess window film cleanly.

The Preparation

You would need the proper materials for this: a sharp knife, typically with a snap-off blade, squeegee, scrubbie pad, any tint solution or application solution, and a clean cloth. Some would opt to use additional materials such as hot air gun and a talcum powder.

The Process

  1. Clean the windows first with the cloth to remove any dust and dirt.
  2. You may opt to use the talcum powder and rub it on the windows with the free cloth.
  3. The cloth should be slightly damp, put a line of water on the window, and this should be in a horizontal position across the center of the window.
  4. Cut the sheet of window tint. Again, it doesn’t have to be a perfect cut as you will be tucking the excess tint. You may opt to search for windshield tint near Oviedo, FL.
  5. Run the squeegee along the line of water.
  6. Arrange the tint carefully. The trick here is that there should be fingers running from the middle to the top and another from the middle to the bottom. This is to ensure that no bubbles will be caught inside the window film.
  7. As of this step, the tint would look like it is wrinkled – don’t worry.
  8. Lift the bottom of the film and apply the solution underneath – and smooth it over with your hand.
  9. Repeat this on the top portion of the film.
  10. Wipe the edges and tuck in any excess window film.

See? Window tint isn’t that bad, but it can be risky for someone who is new to the world of window tinting. Furthermore, it is hoped that this article was able to give you an overview of what to expect for DIY window tinting installers.